NICHOLS Twin Milling Machine Operator's Part Manual

Price:

$49.50

Availability:

In Stock

Manual Description

Number of Pages: 38

This is a reproduction, not a photocopy, of an original Nichols Twin Horizontal Milling Machine Instructions and Parts Manual. This manual contains all the information listed below in the contents.

Nichols

Introduction - The Nichols Twin Mill..............................2
Description.......................................................2
Machine Nomenclature..............................................5
Special Features of Construction..................................2
I The Spindle and its Drive.......................................2
II The Table Cycle................................................2
III Cutter Retraction.............................................3
IV Double Cycle (Roughing & Finishing)............................3
V Brake Motors....................................................6
VI Coolant Equipment..............................................6
Installation Procedure ...........................................6
General Set-Up Procedure..........................................8
Retraction Set-Up Procedure......................................10
Double Cycle Set-Up Procedure....................................11
Maintenance......................................................11
Lubrication......................................................11
Trouble Shooting Hints...........................................13 
To Change Spindle Bearings.......................................15 
ILLUSTRATIONS
Front View - Figure 1.............................................4
Rear View - Figure 2 .............................................4
Head Gear Train-Plan View - Figure 3..............................6
Air Motor and Control - Figure 4 .................................9
Hydro-Check - Figure 5............................................9
Cutter Retraction - Figure 6.....................................10
Lubrication Chart - Figure 7.....................................12
Dimension Drawings - Figure 8....................................17
PLATE INDEX - Figure 9...........................................18
Plate 1. Spindle and Outboard Arbor Support......................20
Plate 2. Primary and Intermediate Shafts.........................21
Plate 3. Saddle and Coolant System...............................22
Plate 4. Knee....................................................23
Plate 5. Table-Rear..............................................24
Plate 6. Table-Front.............................................28
Plate 7. Automatic Way Lubrication...............................33
Plate 8. Cutter Retraction.......................................36
Plate 9. Transverse Pneumatic Feed-Third Slide Type..............37

Overview

I have collected this information for many years and have found the information they contain to be priceless in using and setting up the machines properly. I believe this manual will be a valuable resource of knowledge that will provide a lot of helpful information that is often hard to find. My manuals are not photocopies. I maintain a high standard of quality in my reproductions. Most of the manuals I reproduce look better than their originals. I have professionally digitally edited every page, and removed stains, wrinkles and handwriting. All of the manuals are printed on thick white paper to withstand shop wear and tear; they are then comb bound with heavy cover pages so they lie flat on the workbench.